_______________________________________________________________________________________ 5
PIN
MAX6657
MAX6658
MAX6659
NAME
FUNCTION
1
1
V
CC
Supply Voltage Input, +3V to +5.5V. Bypass to GND with a 0.1礔 capacitor. A 200&
series resistor is recommended but not required for additional noise filtering. See
Typical Operating Circuit.
2
3
DXP
Combined Remote-Diode Current Source and A/D Positive Input for Remote-Diode
Channel. DO NOT LEAVE DXP UNCONNECTED; connect DXP to DXN if no remote
diode is used. Place a 2200pF capacitor between DXP and DXN for noise filtering.
3
4
DXN
Combined Remote-Diode Current Sink and A/D Negative Input. DXN is internally
biased to one diode drop above ground.
4
6
OVERT1
Overtemperature Active-Low Output, Open-Drain. Output is logic low only when
temperature is above the software programmed threshold.
5
7, 8
GND
Ground
6
9
ALERT
SMBus Alert (Interrupt) Active-Low Output, Open-Drain. Asserts when temperature
exceeds user-set limits (high or low temperature). Stays asserted until acknowledged
by either reading the Status register or by successfully responding to an Alert
Response address. See ALERT Interrupts.
7
12
SMBDATA
SMBus Serial-Data Input/Output, Open-Drain
8
14
SMBCLK
SMBus Serial-Clock Input
5
ADD
SMBus Address-Select Pin. The MAX6659 is set to one of three available addresses
(connect to V
CC
, GND, or leave open). See Slave Addresses section.
10
OVERT2
Overtemperature Active-Low Output, Open-Drain. Output is logic low only when
temperature is above the software programmed threshold.
15
STBY
Hardware Standby Input. Temperature and comparison threshold data are retained in
standby mode. If STBY is low, the IC is put into standby mode.
2, 11, 13, 16
N.C.
Not internally connected. Do not make connections to these pins.
Pin Description
?癈, SMBus-Compatible Remote/Local Temperature
Sensors with Overtemperature Alarms
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
MAX6661AEE+T
IC REG FAN SPEED 16-QSOP
MAX6664AEE+T
IC TEMP MON FAN CNTRL 16-QSOP
MAX6665ASA45+
IC FAN CNTRL/DRVR 8-SOIC
MAX6670AUB45+
IC TEMP SENSOR REMOTE 10-UMAX
MAX6678AEP92+
IC TEMP MONITOR 2CH PWM 20-QSOP
MAX6681MEE+
IC TEMP SENSOR SMBUS 16-QSOP
MAX6689UP34+
IC 7CH PREC TEMP MONITOR 20TSSOP
MAX6690MEE+
IC TEMP SENSOR SMBUS 16-QSOP
相关代理商/技术参数
MAX6659MEE-T
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
MAX665C/D
功能描述:电荷泵 DICE SALES DICE RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube
MAX665C/D+
功能描述:电荷泵 RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube
MAX665CPA
功能描述:电荷泵 RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube
MAX665CPA+
功能描述:直流/直流开关转换器 8V Switched-Cap Voltage Converter RoHS:否 制造商:STMicroelectronics 最大输入电压:4.5 V 开关频率:1.5 MHz 输出电压:4.6 V 输出电流:250 mA 输出端数量:2 最大工作温度:+ 85 C 安装风格:SMD/SMT
MAX665CWE
功能描述:电荷泵 8V Switched-Cap Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube
MAX665CWE+
功能描述:电荷泵 8V Switched-Cap Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube
MAX665CWE+T
功能描述:电荷泵 8V Switched-Cap Voltage Converter RoHS:否 制造商:Maxim Integrated 功能:Inverting, Step Up 输出电压:- 1.5 V to - 5.5 V, 3 V to 11 V 输出电流:100 mA 电源电流:1 mA 最大工作温度:+ 70 C 封装 / 箱体:SOIC-8 Narrow 封装:Tube